Remote 1 Terminal - NEC MultiSync XG-1101 Operation Manual

EXAMPLES OF CONNECTIONS

REMOTE 1 Terminal

5 4 3 2
10 9 8
15 14 13 12 11
This terminal is used for either connecting the ISS-6020/ISS-6020G Switcher or a third party external control device. When the
Switcher is used, connect it with the optional control cable (15-15 pin; 50 ft./16m; CTL-6010) to this terminal.
When used with the Switcher.
Pin No. FUNCTION
1, 2, 6 and 7 Sending and receiving data when the Switcher is used.
9 Identifying the Projector
15 Ground
Others Used inside the Projector. Normally set to OPEN.
When using with the Switcher ISS-6020/ISS-6020G, connect no. 1,2,6,7,9 and15 pins of the projector to the same no. pins of the
switcher as shown below.
REMOTE 1 terminal of the Projector
mini D-sub 15 pin (male)
1
7 6
6
1
7
2
9
15
Pins without a number are open.
Pin Configuration of Optional CTL-6010 Cable
Shield (frame ground)
14
REMOTE 1 terminal of the Switcher
mini D-sub 15 pin (male)
6
1
7
2
9
15