When Used In Stand Alone Operation - NEC MultiSync XG-1101 Operation Manual

When used in stand alone operation.

Pin No. SHORT/OPEN
14
SHORT
OPEN
5 SHORT
OPEN
10 SHORT
OPEN
4,8, and 12
12 8
OPEN OPEN
OPEN OPEN
OPEN SHORT
OPEN SHORT
SHORT OPEN
SHORT OPEN
SHORT SHORT
SHORT SHORT
The term "SHORT" means to connect with pin 15
• When in the external control mode, the POWER, INPUT and PICTURE MUTE buttons on the remote control will not function.
NOTE: Pin 13 is the external remote signal terminal. The projector can be controlled by the same format signal as the supplied
remote control from the external controller regardless of setting Pin 14.
NOTE: When turning the power on using the external control, short Pin 5 about three seconds after supplying the AC power to the
projector; when turning the power off using the external control, power off the AC supply to the projector about three seconds after
opening Pin 5. These procedures are to protect your projector and the connected equipment.
External control mode ON
External control mode OFF
POWER ON
POWER OFF
PICTURE MUTE ON
PICTURE MUTE OFF
4
OPEN INPUT A RGB
SHORT INPUT A VIDEO
OPEN INPUT A S-VIDEO
SHORT
OPEN
INPUT B (RGB when RGB INPUT installed) (VIDEO when used as VIDEO INPUT)
SHORT
INPUT B (RGB when RGB INPUT installed) (S-VIDEO when used as VIDEO INPUT)
OPEN INPUT C (RGB when RGB INPUT installed) (VIDEO when used as VIDEO INPUT)
SHORT INPUT C (RGB when RGB INPUT installed) (S-VIDEO when used as VIDEO INPUT)
FUNCTION
15
EXAMPLES OF CONNECTIONS