Table of Contents
Advertisement
1
确认供水角阀及排污口预留尺寸
Check angle valve and drain pipe dimension
坐便器中心线
Toilet center
* 供水角阀为自购件，不包含在马桶产品包装里。
* 排污口孔径请参考相关建筑标准，通常为
110mm。
* 排污管的高度应该为180mm，高度不符合将导
致密封失效甚至无法安装。
2
根据现场的排污管和供水角阀的安装尺寸调整并安装坐便器
Adjust and install the toilet according to the installation size of the sewage pipe and water supply angle valve on site
排污连接直管
Waste pipe
a. 根据实际情况切割直管以达到所需尺寸。
b. 用锉刀将排污管口磨平，以备连接。
c. 安装一个密封圈到排污连接直管尾部。
*供水角阀
* Angle valve
至坐便器方向
T oward to toilet
*墙面排污管
* Drain pipe
* Angle valve is self-purchased part, not included in
toilet product package.
* Drain pipe diameter need to comply with building
standard specification, which is 110mm generaly.
* The height of the sewage pipe should be 180mm. If
the height is not consistent, the seal will fail or even
be unable to be installed.
a. Cut the waste pipe according to actual size.
b. Use a rasp to smooth edges to prepare pipe for connecting.
c. Install a seal ring on the end of the waste pipe.
3
Protruding wall
凸出墙面
80mm Min
180mm
密封圈 (墙排污管) (需自购)
Seal ring for drain pipe (Self-purchased)
Advertisement
Table of Contents
