Table of Contents
Advertisement
WARNING
Towing the machine with material in the drum
increases the risk of a hitch malfunction and tire
failure. In addition, material could bounce out of
the drum and hit other vehicles and/or people.
Material in the drum increases the weight, which
affects momentum and braking distance.
Do not tow the machine with material in the drum.
•
Review and understand
•
Test the brakes of the tow vehicle before towing.
•
Avoid sudden starts and stops while towing the machine.
Preparing to Use the Machine
•
Review all of the safety decals on the machine.
•
Use a hard-hat, hearing protection, a shirt with long
sleeves that are tight at the wrists, tight-fitting gloves
without draw strings or loose cuffs, eye protection, and
a dust mask or respirator. A mesh visor alone does
not provide sufficient eye protection; supplement with
protective glasses.
•
Ensure that you are familiar with the safety regulations
and shutdown procedures described in the Operator's
Manual and the Engine Owner's Manual.
•
Ensure that all guards are in place and in good condition.
•
Ensure that the paddles are in place and in good
condition.
•
Check the fuel and oil levels of the engine.
•
Check all the grease fittings to ensure that the machine
is properly lubricated.
•
When preparing to mix material:
1. Move the machine to a level job-site surface.
2. Remove the machine from the tow vehicle.
3. Chock the front and back of the tires to prevent
the machine from moving.
4. Ensure that the drum is in the mix position
(upright).
5. Ensure that the drum latch is engaged and that the
drum does not rotate toward the dump position.
Safe Operating Practices (page
Opening and Closing the Cowl
Opening the Cowl
1. At the side of the machine where the front cowl and
rear cowl meet, grasp the latch and pull it off from the
latch anchor on the rear cowl
A
3).
1
C
1. Latch
2. Repeat step
1
3. Rotate the rear cowl up and forward until it is fully
positioned on top of the front cowl
Closing the Cowl
1. Rotate the rear cowl rearward and down until the
receiver at the bottom center of the cowl is flush on the
frame of the machine
2. At the side of the machine, grasp the latch and pull it
onto the latch anchor on the rear cowl.
3. Repeat step
2
(Figure
24).
16
(Figure
24).
B
1
2
D
Figure 24
2. Latch anchor
on the opposite side of the machine.
(Figure
(Figure
24).
at the opposite side of the machine
G022323
24).
Advertisement
Table of Contents
