Table of Contents
Advertisement
Checking the Spark Plug
Note: Use a gapping tool/feeler gauge to check and adjust
the gap. Install a new spark plug if necessary.
1. Look at the center of the spark plug
see light brown or gray on the insulator, the engine is
operating properly.
Important: Never clean the spark plug. Always
replace the spark plug when it has a black coating,
worn electrodes, an oily film, or cracks.
1
2
Figure 46
1. Side electrode
2. Center electrode
2. Use a gapping tool for spark plugs or a feeler gauge to
measure the gap between the side electrode and center
electrode
(Figure
46).
3. If the gap is not within the specified range, do the
following:
A. If the gap is too small, carefully bend the side
electrode away from the center electrode until
the gap between the electrodes is 0.7 to 0.8 mm
(0.028 to 0.031 inch).
B. If the gap is too large, carefully bend the side
electrode toward the center electrode until the
gap between the electrodes is 0.7 to 0.8 mm (0.028
to 0.031 inch).
Installing the Spark Plug
Important: Ensure that the gap between the side and
center electrodes is correct before installing the spark
plug.
1. Thread the spark plug clockwise into the spark-plug
hole by hand.
Note: Avoid cross-threading the spark plug with the
threads of the spark-plug hole.
2. Rotate the spark plug clockwise using a 13/16 inch
(21 mm) spark-plug wrench until the plug and sealing
washer are seated
(Figure
3. Tighten the spark plug as follows:
(Figure
46). If you
3
4
G019300
3. Insulator
4. 0.7 to 0.8 mm (0.028 to
0.031 inch) gap
45).
•
When installing an in-service spark plug, tighten
the plug an additional 1/8 to 1/4 turn.
•
When installing a new spark plug, tighten the plug
an additional 1/2 turn.
4. Push the spark-plug wire onto the terminal of the spark
plug
(Figure
44).
Servicing the Spark Arrester
Cleaning the Spark Arrester
Service Interval: Every 100 hours
Note: A spark arrester is available as an option. If you
require a spark arrester, contact your Authorized Toro Service
Dealer.
Genuine Toro spark arresters are approved by the USDA
Forestry Service.
WARNING
If the engine has been running, the muffler will be
hot.
1. Remove the divider plate; refer to
Divider Plate (page
2. Remove the 2 nuts (8 mm) and remove the muffler
from the cylinder
1
2
3
4
5
G019331
1. Deflector (if
5. Exhaust pipe
applicable)
2. Protector
6. Nut, 8 mm (2)
3. Screw (6 mm)
7. Gasket
4. Muffler
8. Bolt (8 mm)
29
Removing the
24).
(Figure
47).
10
12
8
7
6
Figure 47
9. Spark arrester
10. Screws (5 mm)
11. Exhaust port
12. Screw (4 mm)
11
10
9
Advertisement
Table of Contents
