Table of Contents
Advertisement
10. Move the lever of the fuel valve to the On position (all
the way to the right) and check for leaks. If it leaks,
replace the O-ring.
Draining the Fuel Tank
1. Remove the engine; refer to
(page
30).
2. Remove the fuel cap by rotating it counterclockwise.
1
G020122
Figure 53
3. Align a drain pan to the hinge of the engine deck.
4. Rotate the engine on the hinge side of the engine deck
and drain the fuel from the tank.
5. Carefully lower the engine and engine deck.
6. Install the fuel cap.
7. Install the engine; refer to
31).
Removing the Engine
2
Installing the Engine (page
Belt Maintenance
Servicing the Belts
Inspecting the Belts
Service Interval: After the first 25 hours—Inspect the belts
and adjust as necessary.
Every 40 hours—Inspect the belts and adjust as
necessary.
1. Remove the divider plate; refer to
Divider Plate (page
2. Move the clutch lever to the Off position; refer to
Controlling the Paddles (page
3. Examine the belts for wear or damage. If the belts are
worn or damaged, replace them; refer to
the Belts (page
32).
4. Examine the pulleys for wear, damage, and
misalignment; refer to
5. Install the divider plate; refer to
Plate (page
24).
Adjusting the Belt Tension
Clutch air gap: 2.5 to 6.5 mm (3/32 to 1/4 inch)
1. Move the clutch lever to the On position; refer to
Controlling the Paddles (page
2. Measure the air gap between the engine deck and the
roller on the clutch
G019976
1. Engine deck
2. Clutch roller
3. If the measured air gap is not within the specified
range, adjust the gap as follows:
32
Removing the
24).
20).
Inspecting
Aligning the Pulleys (page
Installing the Divider
20).
(Figure
54).
1
2
Figure 54
3. Clutch air gap: 2.5 to 6.5
mm (3/32 to 1/4 inch)
35).
3
Advertisement
Table of Contents
