Table of Contents
Advertisement
Mixing a Batch of Material in the
Machine
1. Ensure that there is no old, loose material in the drum
that can contaminate the batch of material; refer to
Cleaning the Drum (page 22)
(page
21), then return the drum to the upright position.
Note: Ensure that the drum is in the mix position
(upright) and the drum latch is engaged.
2. Move the clutch lever to the Off position; refer to
Controlling the Paddles (page
3. Start the engine; refer to
Note: Allow the engine to warm-up at 2/3 throttle
for 1 to 2 minutes.
4. Set the throttle lever on the engine to the Max position;
refer to
Throttle Lever (page
5. Move the clutch lever to the On position; refer to
Controlling the Paddles (page
6. Add the ingredients for the batch as follows:
A. Pour water into the drum through the grating of
the drum guard.
B. Add the plaster, cement, or other binding material.
Note: You can open bags of cement, plaster, and
binding materials by lowering the bag onto the
bag splitter
(Figure
A
C
Figure 32
C. If you are using sand and/or other reinforcing
materials, add them into the drum.
7. Allow the paddles to mix the material until the
ingredients have a uniform appearance.
Note: If needed, add water or plaster, cement, or
other binding material until the consistency of the
batch is correct.
and
Dumping the Drum
20).
Starting the Engine (page
10).
20).
32).
B
D
G021 179
8. Release the drum latch and dump the drum; refer to
Dumping the Drum (page
Using the Drum
DANGER
Contact with the mixing paddles could cause
damage or injury.
Never put your hands inside the drum at any time.
19).
Dumping the Drum
Note: When dumping a batch of material, leave the engine
running and the clutch in the On position so the rotating
paddles help discharge the material.
1. Align a wheelbarrow or similar container of adequate
capacity in the path of the drum opening.
2. Grasp the dump handle with your left hand
1. Dump handle (mix
position)
2. Drum latch (release
position)
Note: When dumping a batch of material, align a
wheelbarrow or a similar container of adequate capacity
beneath the chute.
3. Lift the handle of the drum latch
4. With both hands on the dump handle, rotate it
counterclockwise to discharge the contents of the
drum
(Figure
Note: Allow the machine to completely discharge the
contents of the drum.
5. Rotate the dump handle clockwise until the drum
latch locks the drum in the upright position
21
21).
G020478
Figure 33
3. Drum latch (locked
position)
4. Dump handle (dump
position)
(Figure
33).
(Figure
33).
1
2
3
4
33).
(Figure
33).
Advertisement
Table of Contents
