Cleaning The Drum - Toro 60213C Operator's Manual

4. With both hands on the dump handle, rotate it
counterclockwise to discharge the contents of
the drum (Figure
Note:
Allow the machine to completely
discharge the contents of the drum.
5. Rotate the dump handle clockwise until the
drum latch locks the drum in the upright position
(Figure 32).
6. After dumping a batch of material, clean
the drum to prevent dried material from
contaminating the next batch of material; refer to
Cleaning the Drum (page

Cleaning the Drum

Important:
Do not strike on the drum with a
shovel, hammer, or any other device to loosen any
accumulated dried materials.
1. Move the clutch lever to the O
the paddles.
2. Shut off the engine/motor.
3. Ensure that the drum is in the mix position
(upright).
4. Spray the machine with water to remove any
accumulated material.
5. Start the engine/motor.
6. Move the clutch lever to the O
the paddles.
7. Dump the drum.
32).
25).
position to stop
FF
position to start
N
25