Table of Contents
Advertisement
OFF
1
Figure 12
1. Off position
Recoil-start Handle
To start the engine, pull the recoil-start handle (Figure 10)
quickly. Ensure that the engine controls described above are
all set correctly for the engine to start.
Oil-level Switch
The oil-level switch is located inside the engine, and it
prevents the engine from running if the oil level is below the
safe operating limit.
Specifications
Note: Specifications and design are subject to change
without notice.
Batch Capacity
Length
(with tow pole)
Width
Height
Weight
Axle
(extendable)
OFF
2
G021 103
2. On position
0.31 cubic m (11.1 cu ft)
255 cm (101 inches)
122 cm (48 inches)
173 cm (68 inches)
389 kg (860 lb)
91 to 119 cm (36 to 47 inches)
Operation
Important: Before operating, check the fuel and oil
levels, and remove debris from the machine. Ensure that
the area is clear of people.
Preparing to Tow the Machine
Important: Ensure that your tow vehicle has towing
capacity for the weight of the machine.
Important: Use a Class 2 or larger receiver.
Note: Ensure that your tow vehicle has the appropriate hitch
to tow the machine; options include a 50 mm (2 inch) ball
hitch or a pintle hitch.
Note: Ensure that the electrical connector of the tow vehicle
is compatible with the electrical connector of the machine.
The machine uses a standard 4-flat plug. If your tow vehicle
has a different type of plug, obtain an adapter from an
automotive parts store.
1. Ensure that the engine is stopped, the fuel valve is off,
and the drum is empty.
2. If the drum has accumulated any water, dump the
drum; refer to Dumping the Drum (page 22), steps 1,
3, 4, and 5.
3. Using the dump lever, position the drum so that it is in
the mix position (upright) and locked.
4. Close the engine cowl and secure the cowl latches
(Figure 13).
5. Extend the axle; refer to Extending the Axle (page 16).
12
G022324
Figure 13
Advertisement
Table of Contents
