Table of Contents
Advertisement
Figure 21
1. Support point (2)
7.
Remove the bolts and nuts that secure the inner
axle to the outer axle
Figure 22
1. Wide position (towing)
2. Narrow position
3. Nut—wide position
8.
Align the inner axle to the desired position as
follows:
•
Slide each side of the axle inward to the
narrow position
•
Slide each side of the axle outward to the
wide (tow) position
9.
Secure the axle with the bolts and nuts removed
previously
(Figure
N∙m (64 ft-lb).
(Figure
22).
4. Nut—narrow position
5. Bolt—wide position
6. Bolt—narrow position
(Figure
22).
(Figure
22).
22) and torque them to 87
Preparing to Use the
Machine
1.
Park the machine on a level surface and
disconnect the machine from the tow vehicle.
2.
Ensure that all guards and paddles are in place
and in good condition.
3.
Perform all daily maintenance procedures
prescribed in
4.
Chock the front and back of the tires to prevent
the machine from moving.
5.
Move the drum to the upright position and lock it.
g020019
Opening the Cowl
g020020
20
Maintenance (page
27).
Figure 23
g035134
Advertisement
Table of Contents
