Data Transmission From Ba-Ble Via The Rs-232 And Rs-485 Wired Interfaces - 3scort BA-BLE 5.0 LR User Manual

2.3.10 To delete a sensor, press and hold on it and swipe to the left, the Remove button will
appear on the right, tap on it and the sensor will be deleted (Fig. 14). Next, confirm your action by
pressing the Disconnect button (Fig. 15) .
Fig. 14 Deleting a sensor from BA-BLE

Data transmission from BA-BLE via the RS-232 and RS-485 wired interfaces

2.3.11 The data can be requested from the BA-BLA via the RS-232 and RS-485 interfaces in
accordance with the LLS communication protocol. To configure the RS-232 and RS-485 interfaces, press
on one of the sensors (Fig. 16) and then press the RS-232 and RS-485 button (Fig. 17). You will see the
list of the pairs of parameters that can be transmitted by the BA-BLE in response to the requests from
an external device, for example GPS tracker/gateway (Fig. 18).
2.3.12 To switch the transmission of the pair of parameters you need, tap on it to switch the
tumbler to the right.
Next, you will be asked to select a network address via which the activated pair of parameters
will be transmitted to the external device. The network address can be 0...255. Press "Save" to apply
the change. Figure 19 shows an example of the network address 2 being used to transmit the fuel level
and temperature of a TD-BLE sensor in accordance with the LLS protocol. Figure 20 and 21 show the
menu of the parameters and the network addresses used to transmit them.
ESCORT. BLUETOOTH BASE BA-BLE 5.0 LR
User Manual 2022.02-24. Page 13 of 38
memory
Fig. 15 Deleting a sensor from BA-BLE
memory