Deck Mount Mixer A7224Aa - Ideal-Standard Ceratherm T50 Installation Instructions Manual

7.3

Deck mount mixer A7224AA

• Loosely assemble both of the bath legs to the main body of the mixer, ensuring the fibre-mesh seals
shown are located within the captive nuts. Hand tighten both captive nuts sufficiently to hold the
assembly securely together. NOTE, the bath legs are handed left & right.
• Make sure that deck seals are located in the recesses in the bottom face of both bath legs.
The back- nuts & washers will be fitted from the underside of the bath. If they are already assembled
to the legs, they should be removed.
• Offer the tails of the legs into the two holes in the bath. Align the legs and gently lower the mixer onto
the rim of the bath. IMPORTANT: make sure the deck seals are still correctly located in the recesses of
the bath legs, otherwise splashed water may seep pass the legs and onto the floor under the bath.
• The back-nuts & washers can be fitted to the tails from under the bath. Keeping the tails central in the
bath holes, check that the mixer is still positioned correctly on the bath rim, and then tighten the
back- nuts. Use 32mm A/F spanner.
• The captive nuts connecting the mixer to the legs can also be tightened, use a strap wrench or 30mm
A/F spanner, taking care not to damage the chromed surfaces.
• Connect the water supply pipes to the inlet tails of the mixer using straight tap connectors.
Connect HOT supply pipe to the left inlet leg and COLD supply pipe to the right inlet leg.
• Check all joints are tight, turn on the water supplies and check for any water leaks.
• The hose from the shower kit should be connected to the shower outlet located on the underside of the
mixer body. Ensure hose seal is in place.
32
17
Note: the mixers supplied with A7225AA
& A7227AA are fitted with an additional
outlet nipple on the top surface to connect
the over head shower plate.
Smear a small amount of approved sili-
cone grease onto the O-ring fitted on the
nipple. This will help to prevent damage
to the O-ring during assembly.
Use a WRAS approved silicone grease
(eg: Klueber Unisilkon L250L).
30