Ideal-Standard Ceratherm T50 Installation Instructions Manual page 14

2
3
4
5
Pipe trimmed level
with wall brackets
14
Place the brackets over the exposed
pipes and use the template provided to
position them 150mm apart.
Mark the hole positions for the fixings
onto the mounting surface.
Ensure that the positions of the holes
will not result in damage to the pipework
inside the wall cavity during drilling.
Drill holes appropriate for your choice of
fixings into the wall.
We recommend a minimum of two fixings
per bracket diametrically opposed.
Drill carefully to avoid damaging conce-
aled pipework.
The pipes should be trimmed level to
the wall bracket. If using a pipe cutter
it will be necessary to mark the pipes
and then remove the bracket before
trimming to its correct length.
Apply a smear of silicone sealant to
the rear of the assembled brackets and
push them over the pipework.
Screw both brackets to the wall.
The template can be used to check that
the correct pipe spacing of 150mm has
been maintained.
Clean off excess sealant and flush the
pipes to remove any trapped debris.