Advertisement
11. Attach pointer to sled with (2) M5-.8 x 10 but-
ton head cap screws (see Figure 10).
Figure 10. Pointer attached to sled.
12. Adjust sled on rails until edge of sled is flush
against bandsaw blade (see Figure 11), then
move sled handle down to lock position on
rails.
Blade
Sled
Handle
Figure 11. Sled edge flush and locked in
position against blade.
13. Mark location of pointer on front rail (see
Figure 12).
-4-
x 2
Pointer
Mark
Figure 12. Pointer location marked on rail where
sled contacts blade.
14. Lift sled handle to unlock position, then
remove bandsaw sled from rails.
15. Remove sticker-back from scale and adhere
scale to front rail, aligning 0" on scale with
mark from Step 13 (see Figure 13).
0" on Scale
Figure 13. Scale attached to front rail.
Note: If you adjust rail position, scale will
no longer be accurate. If you think you may
adjust rails, affix scale with tape for now.
16. Lift sled handle and install bandsaw sled on
rails.
17. Refer to Model T32839, Model T32840, or
Model T32841 instructions to install accesso-
ries for crosscut, miter, or milling operations.
Model T32838 (Mfd. Since 11/21)
Mark
Advertisement
