Advertisement
Assembly
The existing rails on your bandsaw must be
removed to install the Model T32838.
Wear safety glasses during
the entire setup process!
Items Needed
Vertical Wood-Cutting Bandsaw ....................... 1
Tools to Remove Bandsaw Rails ....... As Needed
Safety Glasses (For Each Person) ...............1 Pr.
Wrench or Socket 8mm ..................................... 1
To assemble bandsaw sled:
1.
DISCONNECT BANDSAW FROM POWER!
2.
Remove existing rails on your bandsaw.
3.
Install (2) front rail mounting brackets to front
of bandsaw table (see Figure 3) using hard-
ware removed in Step 2. Only finger-tighten
for now.
Note: T32838 comes with (4) M6-1 x 16 hex
bolts, (4)
⁄
"-20 x
1
4
flat washers. These can be used instead of
hardware from Step 2 if they fit your machine.
Front Rail
Mounting Bracket
(1 of 2)
Figure 3. Example of front rail mounting
brackets installed on bandsaw table.
-2-
Qty
⁄
" hex bolts, and (4)
5
1
8
Bandsaw
Table
4.
Install (2) rear rail mounting brackets to
rear of bandsaw table (see Figure 4) using
hardware removed in Step 2 (or hardware
included with T32838). Only finger-tighten for
now.
Rear Rail
Mounting Bracket
(1 of 2)
Figure 4. Example of rear rail mounting brackets
installed on bandsaw table.
5.
Loosely install (2)
and
⁄
"-18 square nuts on front rail mounting
5
16
brackets, as shown in Figure 5.
⁄
"
4
Figure 5. Knob bolts and square nuts installed
on front rail mounting brackets.
Bandsaw Table
⁄
"-18 x
⁄
" knob bolts
5
5
16
8
Front Rail
Mounting Bracket
(1 of 2)
x 2
Model T32838 (Mfd. Since 11/21)
Advertisement
