Advertisement
6.
Slide square nuts into T-slot on bottom of
front rail, as shown in Figure 6, then tighten
knobs to secure rail position.
Note: To allow for longer workpieces, adjust
rail as far right as possible where it can still
be secured by left knob.
T-Slot
Figure 6. Installing front rail.
7.
Repeat Steps 5–6 with rear rail, aligning rear
rail edges to front rail edges.
8.
Lift sled handle and place sled assembly on
rails and bandsaw table (see Figure 7).
Front Rail
Sled Handle
Figure 7. Sled placed on front and rear rails.
Model T32838 (Mfd. Since 11/21)
9.
Rear Rail
10. Adjust rails up or down as needed so sled
Loosen or remove (2) cap screws, fender
washers, and hex nuts shown in Figure 8
to adjust or re-install bumpers so they are
directly above rear rail.
Figure 8. Location of bumper fasteners.
Note: If you cannot install bumpers directly
above rear rail, you can also adjust place-
ment of fasteners shown in Figure 9 so sled
better fits your bandsaw table.
x 4
Figure 9. Location of sled frame position
fasteners.
is slightly above table, then tighten fasten-
ers from Steps 3–4. Bumpers should con-
tact rear rail and sled should slide smoothly
across rails and table.
Note: You may need to position rear rail out
of the way in order to access fasteners.
x 2
Bumper
(1 of 2)
-3-
Advertisement
