Chapter 4 Setting Parameters - Denso GT10Q-SR Operator's Manual

Chapter 4 Setting Parameters

You may easily set parameters for communications conditions and readable codes in the
following two ways. Settings made in these ways will be retained even after the power is
turned off.
(1) Scanning parameter setting QR codes in the QR-coded parameter menu by pressing the
trigger switch.
The QR-coded parameter menu in Appendix 2 allows you to make basic settings.
(2) Using the Setting Software* to be run in your PC. (With the program, you may generate
a batch-process QR code to be scanned for setting.)
* The User's Manual and Setting Software can be downloaded from our Web site at
http://www.denso-wave.com/.
This chapter describes how to set parameters with the QR-coded parameter menu.
Parameter setting procedure using the QR-coded parameter menu
"Start setting"
↓ The beeper sounds three times.
Scan parameter setting
QR codes.
↓ The beeper sounds three times.
"End setting"
Scanning the "Defaults" QR code in the QR-coded parameter menu makes all items in the
menu revert to the factory defaults.
TIP: "Beeper volume" QR code in the QR-coded parameter menu
To set the beeper volume, you do not need to scan "Start setting" or "End setting" QR code.
Scanning the "Beeper volume" QR code cycles through the three beeper volume settings--High,
Medium, and Low. The factory default is High.
Scan the "Start setting" QR code.
Scan necessary parameter setting QR codes.
NOTE: When using the QR-coded parameter menu, scan QR
codes within three minutes. Otherwise, the scanner cancels
newly scanned parameters and returns to the previous
settings.
Scan the "End setting" QR code.
6