HAKO Scrubmaster B45CL Manual

Hako Scrubmaster B45CL

1. Disconnect mains plug of the charger from outlet and fasten to holder 1.

2. Fill the clear water tank after folding up the opening 2. Control the filling level

by the filling level indication 3.

3. Switch the machine on by the key switch 4. All aggregates are in standby.

4. Use lever

to lower squeegee 14.

5. Use pedal

6. Adjust driving direction with switch

7. Pull the bail

switches on.

8. Use switch

Qualified persons only are authorised to operate the machine!

The machine is not designed for coarse material! Floor area sweeping before!

Use only cleaning agents suitable for automatic machines ( low-foaming )!

Please pay attention to the informations in the instruction manua!

OPERATION:

to lower brush head.

of the bailsystem. Brush head drive and suction turbine

to adjust the water ( if necessary )

NOTE! Make sure that pad / brush is installed!!!

and speed with potentiometer

11.

Table of Contents

Do you have a question about the Scrubmaster B45CL and is the answer not in the manual?

Page 1 Hako Scrubmaster B45CL OPERATION: 1. Disconnect mains plug of the charger from outlet and fasten to holder 1. 2. Fill the clear water tank after folding up the opening 2. Control the filling level by the filling level indication 3.
Page 2 Hako Scrubmaster B45CL MAINTENANCE AND CARE: Daily maintenance: Weekly maintenance:  Empty clear water tank by opening the  Check and clean brush head / fresh water filter covering Check and sealing strip clean filter if required.  Clean the machine from outside ...