NeuraLabel Callisto User Manual page 59

Die-cut labels are printed using Labels Print Mode and Black Mark or Gap Mark Mode. Mark
Adjustment is in inches or centimeters and is usually close to 0. There are no other parameters
on this page that need to be set for overriding label printing.
Figure 8-12. Print Parameters
Remember that normally there is no need to override the printer driver parameters. However
these settings are whenever the correct configuration for printing labels seems to be failing for
any reason.
Printhead Height allows the printer printhead height to be overridden with values specified in
this view. A value of Auto (0), Low, Medium or High can be selected, or a Custom value can be
selected. Selecting override on this view will ignore the printhead value in the driver and use
the value specified on this panel. A value of Auto is often sufficient for most label media.
If you have thick or problematic media in the printer, and you want to ensure all users use a
higher printhead setting, this override option is a good way to guarantee the specified height
will be used.
8-46