NeuraLabel Callisto User Manual page 44

Virtual Driver Page Size
Width
Length
It is critical to create the proper label page size to work your die-cut media. Die-cut media will
normally have a gap in between individual labels. This gap will be between 0.125" and 0.5". It
is also possible for the die-cut media to have no gap, such as when the matrix has been left on
the media. The matrix is the excess part of the die-cut media that is not part of the label. In
the case that the matrix has been left on the media, the media must have a mark on the back to
distinguish the individual labels. The Callisto printer has a center-based gap/mark sensor and
requires a center mark for marked media.
Note that the Callisto printer itself has a "gap between pages" requirement for printing die-cut
labels. This is due to the geometry of the stationary printhead. However any label within the
width and length specification can be printed with the right media and page size definition.
When creating the page size in the driver for a specific die-cut media, you will need to account
for the label size and the label gap. The steps for successfully creating the best label page size
for any given media will be discussed in the User Guide Section
Actual maximum page size width is 11.99 inches.
1
2 Virtually unlimited page length printing is supported in special banner mode.
Minimum
0.4 inches (1.02cm)
0.4 inches (1.02cm)
Table. Printer Diver Page Constraints
7-31
Maximum
12 inches 1 (30.48cm)
35.5 inches 2 (90.17cm)
Printing Labels
.