Disassembly And Assembly - Shure AMS8100 Service Manual

Previous

Disassembly and Assembly

25A1041 (RA)
Shure AMS8100 Automatic Microphone Mixer
! CAUTION !
Observe precautions when handling this static-sensitive device.
! WARNING !
Voltages in this equipment are hazardous to life. No user-serviceable
parts are inside. Refer all servicing to qualified service personnel.
The safety certifications of the AMS8100 do not apply when
the operating voltage is changed from the factory setting.
Front Panel Pots
In this state of disassembly, most components can be accessed
and the mixer can be powered and work properly. To replace front
panel pots:
1. Do not remove any of the snap-in LEDs from the front panel.
2. Remove the top and bottom covers.
3. Remove the six nuts behind the front panel
4. Remove the two nuts and washers on the front panel
phone jacks.
5. Remove the four screws holding the front panel to the chassis.
6. Carefully lift the front panel out of the way (with the snap-in
LEDs still connected).
7. Loosen the pot to be replaced.
8. Desolder the pot, lift it out, and install new pot.
9. Reassemble the unit in reverse order.
11 Disassembly and Assembly
Products