Insertion System - CanadianSolar CS6R-MS Installation Manual

6.3 INSERTION SYSTEM

 Insertion Method C shown below is recommended only for
monofacial modules.
 Insertion methods can vary and depend on the mounting
structures. The installer needs to follow the mounting
guidelines recommended by the mounting system supplier.
Each module must be securely maintained through all its
length on two opposite sides. Install and tighten the
insertion profiles to the support structure using the
hardware and instructions provided by the mounting
system manufacturer. The system designer and installer
are solely responsible for load calculations and for the
proper design of support structure.
 Canadian Solar warranty may be void in cases where
improper insertion systems or unsuitable installation
methods are found. When installing insertion profiles,
please take the following measures into account:
1. Do not bend the module frame.
2. Do not touch the front glass or cast shadows onto it.
Insertion Method A
Two insertion profiles run parallel to
long side frame.
Installation Method
Module Types
CS6W-MS (F35A Frame)
CS6R-MS/CS6RA-MS/CS6RB-
MS
CS6R-MS-HL
CS6L-MS (Preliminary)
CS6R-H-AG/CS6RA-H-AG
CS6W-MB-AG
*: Just for CWF 0% overhang- insertion profile completely wraps the frame without cantilever. Rail distance must be ≥50% frame
from the short end of one side of the module.
EN-Rev IM/GN-EN/1.0 Copyright © January, 2023. CSI Solar Co., Ltd.
3. Do not damage the surface of the frame.
4. Ensure that the insertion profiles overlap the module
5. Ensure that the module frame (C-shape) overlaps the
6. Ensure insertion profile thickness and tolerances suit
Insertion Method B
Two insertion profiles run
perpendicularly to long side frame.
Insertion Method A
+4000Pa/-2400Pa
+4000Pa/-2400Pa
+5400Pa/-2400Pa
+3600Pa/-2400Pa
+3600Pa/-2400Pa
+3600Pa/-2400Pa*
frame by at least 10 mm (0.39 in).
insertion profiles by at least 15 mm (0.59 in).
module thickness.
Insertion Method C
An additional support bar used with
clamps
Insertion Method B
+1500Pa/-1200Pa
+2200Pa/-2200Pa
+2400Pa/-2400Pa
+1200Pa/-1200Pa
+2400Pa/-2400Pa
/
| 23
Insertion Method C
+5400Pa/-2400Pa
/
+5400Pa/-2400Pa
/
/
/
www.csisolar.com