HP HPE StoreEasy 1000 Getting Started Manual page 14

Procedure
1. Power down the HPE StoreEasy 1560 Storage.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the HPE StoreEasy 1560 Storage.
3. Disconnect all peripheral cables from the HPE StoreEasy 1560 Storage.
4. Place the HPE StoreEasy 1560 Storage on the side with the access panel facing up.
Install the rack rails and tray
These rack rails can be installed in both round- or square-hole racks.
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• Tray
• T-15 Torx screwdriver
Procedure
1. Follow the steps to disassemble the rail assemblies:
a. Pull out the inner rail until it is fully extended .
b. Slide and hold the white release tab in the direction shown, and then remove the inner sliding rail from the outer
mounting rail.
14
Setup and install