Advertisement
20. Display of the measured type and the value of the corresponding channel, see
an automatic measurement
21. Cursor measurement window, see
22. /The yellow line shows the reference point to ground (zero position) of the CH2 waveform. If the
line is not shown, it means that this channel is switched off. (Red line is for CH1).
24. the waveform of CH1
F5:
Ctrl + Enter:
Q:
A:
W:
S:
E:
D:
R:
F:
←:
→:
F1:
Status information guide
Auto
Ready
TRIG'D
Scan
Stop
Error
ReSyncing
AutoSet
The status when the oscilloscope is not connected:
Offline
USBFound
USBDrvEr
MachineNotSupport Cannot recognise device
The status when the oscilloscope is connected:
Linking
Connect
Match
Syncing
12. Measurements with the cursor
Run/Stop
Autoset
The voltage division of channel 1 is reduced by one step.
step
The voltage division of channel 1 increases by one step.
step
The voltage division of channel 2 decreases by one step.
step
The voltage division of channel 2 increases by one step.
step
The voltage division of channel 3 decreases by one step.
step (only P 1326 and P 1331)
The voltage division of channel 3 increases by one step.
step (only P 1326 and P 1331)
The voltage division of channel 4 decreases by one step (only P 1326 and P 1331).
(P 1326 and P 1331 only)
The voltage division of channel 4 increases by one step.
step (P 1326 and P 1331 only).
Time base decreases by one step
Time base increases by one step
Open the help
Automatic trigger mode
Ready for a trigger
Has triggered
Slow Scan
Data acquisition stopped
An error has occurred
Synchronise with the oscilloscope again
In Process of self-registration
No USB connection with the oscilloscope.
Available USB devices found
Error during USB driver installation
Connection with oscilloscope active
Connection successful
Matching to oscilloscope
Synchronise settings
Keybord shortcuts
-18-
10. To perform
Advertisement
