Table of Contents
Advertisement
H12DSU-iNR User's Manual
System Thermal Sensor Header
A System Thermal Sensor header for IPMI 2.0 is located at JSEN1. Connect the appropriate
cable here to use the thermal sensor I
SATA Ports
The H12DSU-iNR has eighteen SATA 3.0 ports (SATA0-17) that are supported by the
System on Chip chipset.
NVM Express Connections
Four NVM Express ports are located on the serverboard (two for each processor). These
ports provide high-speed, low-latency PCIe 4.0 x4 connections directly from the CPU to
NVMe Solid State Drives (SSD). This greatly increases SSD data-throughput performance
and significantly reduces PCIe latency by simplifying driver/software requirements resulted
from direct PCIe interface from the CPU to the NVMe SSD drives.
C connection on your system.
2
JSEN1 Header
Pin Definitions
Pin#
Definition
1
Data
2
Ground
3
Clock
4
3.3V_Standby
44
Advertisement
Table of Contents
