Triumph Tiger 850 Sport Owner's Handbook Manual page 30

GENERAL INFORMATION
30
Engine Stop Switch
In addition to the ignition switch being
turned to the ON position, the engine
stop switch must be in the RUN position
for the motorcycle to operate.
The engine stop switch is for emergency
use. If an emergency arises which
requires the engine to be stopped, move
the engine stop switch to the STOP
position.
Note
Although the engine stop switch stops
the engine, it does not turn off all the
electrical circuits
difficulty in restarting the engine due to
a discharged battery. Ordinarily, only
the ignition switch should be used to
stop the engine.
Do not leave the ignition switch in the
ON position unless the engine is
running as this may cause damage to
electrical
discharge the battery.
and may
Caution
components and
Starter Button
The starter button operates the electric
starter. For the starter to operate, the
clutch lever must be pulled to the
handlebar.
Note
Even if the clutch lever is pulled to the
handlebar, the starter will not operate if
the side stand is down and a gear is
engaged.
Hazard Warning Lights Button
To turn the hazard warning lights on or
cause
off, press and release the hazard
warning light button.
The ignition must be switched on for
the hazard warnings lights to be
activated, but the hazard lights will
remain active if the ignition is switched
off until the hazard warning light button
is pressed again.
will