Assembling The Mta128St-Usb; Connecting The Mta128St-Usb; Connecting To Your Computer - Multitech MTA128ST Quick Start Manual

External isdn terminal adapter

Hide thumbs Also See for MTA128ST:

Table of Contents

Assembling the MTA128ST-USB

The only assembly required is to mount the feet on the bottom of the unit. Peel the four self-

adhesive plastic feet off the backing strip and press them into the recesses on the bottom.

Place the MTA128ST-USB terminal adapter in a convenient location. In a typical configuration,

you will need to connect your MTA128ST-USB to your computer's USB port, to its own power

supply, to the ISDN network terminator, and to any optional analog equipment you are using

(e.g., a telephone).

1. Plug the 4-pin flat end (Type A) into a USB port connector on your computer or laptop.

Note:

Do NOT plug the "D-shaped" end (Type B) of the USB cable into the USB

connector on the back panel of the MTA128ST-USB at this time. You will be directed to

make the connection during the software driver installation process.

Multi-Tech Systems, Inc. MTA128ST-USB External ISDN Terminal Adapter PN S000340

MTA128ST-USB Connection

Chapter 1 – Introduction and Description

Table of Contents