Installation In Windows 98/Me - Multitech MTA128ST Quick Start Manual

Installation in Windows 98/ME

The MultiModemUSB driver files for Windows ME are installed in two groups, as described
below. The installation wizard begins by installing certain driver files. At that point, Windows
ME detects the modem as a new device. Then the installation wizard runs again to install the
remaining driver files.
1. Power up your Windows ME computer.
2. Turn on your MTA128ST-USB. The LS (Power) LED will light.
3. If you have not already done so, make all the necessary connections.
4. Place the MultiModemUSB CD into the CD drive of your PC. Windows ME will detect
that the new modem is present and launch the Add New Hardware Wizard screen.
This message then displays: "What would you like to do?"
5. Choose Specify the location of the driver (Advanced) and click Next.
6. At the Add New Hardware Wizard "Windows will search for new drivers ..." screen,
uncheck the "Removable Media" button (if necessary) and check "Specify a location."
7. Click the "Browse" button and navigate to the "Windows ME" subfolder of the
"Drivers" folder on the MultiModemUSB CD. Click OK. Click Cancel if it prompts you
for a floppy disk.
8. The Windows driver file search screen appears. Click Next.
9. Transient progress screens will appear while files are being copied. After the files
have been copied to your PC, an Add New Hardware Wizard screen will appear
indicating that Windows has finished installing this the first of two drivers.
10. Click Finish to complete the installation of this first driver.
11. The wizard will close.
12. Windows ME will now detect an "Unknown Device" and begin another Add New
Hardware Wizard, again asking, "What would you like to do?"
13. Choose "Specify the location of the driver (Advanced)" and click Next.
14. At the next screen (the Windows will search for new drivers screen), uncheck the
"Removable Media" button (if necessary) and check "Specify a location." Click Next>.
15. Transient screens will appear while files are being copied.
16. The Windows driver file search screen appears. Click Next.
17. After files are copied, a completion screen appears.
18. Click Finish to complete the installation of this the second driver. The wizard will
close.
19. Remove the MultiModemUSB CD from the computer's CD drive.
Multi-Tech Systems, Inc. MTA128ST-USB External ISDN Terminal Adapter PN S000340
Chapter 2 – Software Installation
16