CONTENTS - Safety precautions p. 4 - Cleaning p. 5 - Replacing the batteries p. 6 - Operation p. 7 p. 7 View each readout p. 7 Resetting your monitor - Data readouts p. 8 - Troubleshoot p. 9 - Contact details p.
SAFETY PRECAUTIONS The monitor on this machine has been tested to the required standards, each of those passed regulations are shown via the following symbols: ROHS - This is an abbreviation for “Restriction of (the use of certain) Hazardous Substances in electrical and electronic Equipment”.
CLEANING Please take care when cleaning this monitor as the LCD screen can easily be scratched. You will need a soft dry cloth Do not spray cleaning chemicals directly onto the monitor Do not apply water to the monitor as it is electrical and may damage the internal components...
REPLACING THE BATTERIES STEP 1 STEP 2 Press the small clip under the monitor to release Remove the old batteries. it from the base. STEP 3 STEP 4 Insert the new batteries the correct way round. Press the monitor back into the base.
VIEW EACH READOUT The R200 has a single button, press this once to exit ‘Scan’ mode. Continuously press this button to scroll through each readout, small black arrows on each side will indicate which readout is currently visible.
DATA READOUTS Readout Measurement Time Minutes : Seconds Count 0 - 999 Distance Kilometres Total Count 0 - 999 Count/Min Average number of strokes per minute...
TROUBLESHOOT Issue Resolutions No power to the monitor • Make sure the batteries are fully inserted and the correct way round. • Check your connection wires from the monitor to the base. They must not be trapped, fully connected and the pins must be straight.
Need help?
Do you have a question about the R200 and is the answer not in the manual?
Questions and answers