EcoSmarte Pool System Manual page 37

GLASS FILTERS WILL NOT LOAD PHOSPHATES
12
SETTING MULTIPLE DAYS OF IONIZATION
Use >< Keys to set
^
Day Run
SU OFE
Press NEXT when done
MANUAL FUNCTION
The MANual feature is used to set the IONization time to be equal to
the POOL run time. This feature is usually used at start-up when you fill your
pool or need to make a gross adjustment in the copper level in your water.
To activate this, simply push the "MAN" key once. This will set your
ION Time to be equal with your POOL run time, and your OXY Time will read
NONE. Your pool will now IONize when your pump is running. If you need to
manually IONize longer, simply go into your POOL setup, and change the Start
and Stop times of your pump. Then return to the "Home Screen" and press the
"MAN" key to change the ION Start and Stop times. Your screen will now look
as shown:
10:09:51A
Pool 10:00A-
Oxy None
Ion 10:30A-
Actual ION hours required to get your first residual will be a function of
total gallons, TDS (total dissolved solids) and pH below 7.2 of your pool. A water
test seeking 0.5 ppm copper should be taken before 10 hours of POOL and ION
running time have passed. PH will rise during initial ionization, therefore, daily
adjustments may be necessary at first.
The manual override key "MAN" is the most convenient method to put
copper constantly to your pool. Select the "OXY" key to switch the unit back to
oxygen equal to your programmed POOL run time.
AUTOMATION
Your water will become predictable after three weeks
and the ION and CO2 values can auto repeat for
weeks, after dialing them in with the water tests.
Set "ION" to come on the day before you test (or your
service) the copper each week.
Start Stop
10:00A- 4:00P-
1/04/2006
4:00P+
3:30P+
5