Table of Contents
Advertisement
Chapter 2 – Installation
Attaching the MultiConnect to a Fixed
Location
The MultiConnect device server is design to be used on the desktop or to be panel-mounted. To attach the bracket
for panel-mounting, following these steps:
1.
Typically, the MultiConnect device server is mounted against a flat surface with two mounting screws. Drill the
mounting holes at the desired location. The mounting holes must separated by 4 -15/16 inches center-to-center.
2.
To attach the brackets to the MultiConnect, slide the mounting brackets into the corresponding slots on the back
of the MultiConnect chassis.
3.
Attach the device server to the surface with two screws.
Multi-Tech Systems, Inc. Serial-to-Serial Device Server User Guide (S000354C)
Chapter 2 – Installation
8
Advertisement
Table of Contents
