Chapter 3 - Managing And Configuring The Multiconnect; Two Ways To Login; Login Using Tty; Login Using Telnet Through The Ppp Interface - Multitech MTS2SA User Manual

Chapter 3 – Managing and
Configuring the MultiConnect

Two Ways to Login

Login Using TTY

•
Use TTY to configure your MultiConnect for the first time. Configure the host serial port using the
defaults listed below:
Baud: 115.2K
Data: 8
Parity: N
Stop: 1
Flow-Control: None
•
Press the Enter key three times to get to the Login prompt or send three carriage returns.
•
At the Login prompt, type admin.
At the Password prompt, type admin.
Important: The user name and password are case sensitive. They must be typed in lowercase letters.

Login Using Telnet through the PPP Interface

•
Open the PPP interface on the modem port.
•
Upon successful establishment of a Telnet session, the MultiConnect displays the Login prompt.
At the Login prompt, type admin.
At the Password prompt, type admin.
•
After a successful login, the MultiConnect IP enters Command Mode. In Command Mode, the
MultiConnect can be configured and managed using the Command Line Interface (CLI) command set.

About Command Mode and Data Mode

•
In Command Mode, a # sign designates the prompt. If you type the word Help at the command prompt, a
complete list of commands displays.
•
If you type the word Usage at the command prompt, a list of the command semantics displays.
•
In Data Mode, the # sign is not displayed.
•
To leave Command Mode, exit your terminal or Telnet session or type the word Exit at the command prompt.
Note: See the Restore command and IP Escape String command.
Multi-Tech Systems, Inc. Serial-to-Serial Device Server User Guide (S000354C)
Chapter 3 – Managing and Configuring the MultiConnect
11