Multitech MultiConnect BT MTS2BTA User Manual page 14

Example of a Slave Command Sequence
From Power Up:
Check and verify Communication to Slave.
1.
Sent: AT<cr>
Reply: <cr_lf>OK<cr_lf>
Get information on Slave Bluetooth address.
2.
Sent: ATSI,1<cr>
Reply: 12-digit address
Set Slave to automatically connect in Fast Data Mode and SPP on Bluetooth connection.
3.
Sent : ATSW25,0,0,0,0 <cr>
Reply:<cr_lf>OK<cr_lf>
Either cycle power or send ATURST.
4.
Note: This command sequence assumes the radio is set to factory defaults that allow it to
automatically come up and be ready to connect as a Slave from a Master request.
Multi-Tech Systems, Inc. Serial-to-Bluetooth Adapter User Guide (S000370B)
<cr_lf>OK<cr_lf>
Chapter 3 – AT Commands and Configuration Examples
14