Table of Contents
Advertisement
7.3 Compressed air connection
To operate the sand blasting cabin you need a compres-
sor with at least 700 liters / min filling capacity and a con-
tainer size of at least 100 liters. The generated air must
be cleaned, free of condensate and oil-free.
Adjustable operating pressure: approx. 3.4 - 8.6 bar.
ATTENTION!
Moisture in the compressed air impairs the flow of
abrasive and can cause clogging and clogging of val-
ves and line.
Always eliminate sand accumulation in the pipes!
8
Commissioning
WARNING!
danger of life!
There is danger to your life if you do not follow these
rules.
- Never work on the blast cabinet if you are under the
influence of alcohol, drugs or medicines and / or
you are overtired or suffer from concentration-im-
pairing illnesses.
- The sandblasting cabin may only be operated by
one person. Other persons must keep away from
the work area during operation.
ATTENTION!
HEALTH HAZARD
Inhaling of blasting material and abrasion may result
in lung damage due to fumed silica!
Possible formation of a silicosis. Information on this
https//de.wikipedia.org/wiki/Silikose
Particularly hazardous is the inhalation of substances
with particle sizes below 5 microns!
Never use blasting media smaller than 0.12 mm and
make sure that the cabin is completely watertight.
Wear respiratory protection.
Use ear protection!
During operation, a noise level of over 85 dB (A) may
occur. From 85 dB (A), ear protection must be worn!
Use safety goggles!
SSK 4 | Version 1.08
Use respiratory protection!
Use safety shoes!
Use protective clothing!
NOTE!
Before using the sand blasting cabin for the first time,
carry out the following points.
- Check all screw connections on the installed sand-
blast cabinets and tighten them if necessary.
- Check the sand blasting cabin for leaks.
- Check the function of the door monitoring. When
opening the cabin doors during operation, the sand-
blasting cabin switches off automatically.
.
Fig. 5: Mechanical door closing mechanism
ATTENTION!
The sandblasting gun must always be directed away
from the operator. Never work with the sandblasting
cabin door open.
ATTENTION!
Never use sand as abrasive.
ATTENTION!
The workpiece must be clean and dry.
NOTE!
The distance of the blasting gun to the object plays an
essential role and should not exceed 20 cm.
Commissioning
9
Advertisement
Table of Contents
