Table of Contents
Advertisement
Care, maintenance and overhaul
In order to meet the most varied requirements, various settings
must be made before the operation for the trouble-free operation
of the sand blasting cabin..
Proper functioning depends on various factors. On the
one hand, a clean and dry blasting medium and free li-
nes are an important prerequisite (operating pressure as
in the technical data). On the other hand, it depends on
which workpieces are to be processed with which abra-
sive, because each workpiece and abrasive has other
properties (hardness, grain size, weight, aggressive-
ness). The blasting media (e.g., normal, mixed, noble
corundum, crushed slag, glass beads, blasting balls,
etc.) are offered in various grain sizes.
Due to these different parameters, different settings must be
made to ensure proper functioning of the sand blasting cabin.
Adjustment of the blowgun
The generated negative pressure in the blow gun can be
determined by the depth of engagement of the compo-
nent [Pos. 7], if the lock nut [Pos. 5] and release the air
pressure connection [Pos. 8].
Fig. 6: Blow
Both settings are interdependent! It should always be tried seve-
ral settings to achieve an optimal result..
Here are two examples and their effects:
- too deeply screwed in component [pos. 7] (small di-
stance inside to the nozzle): too little negative
pressure and thus also little abrasive
- too far back turned component [pos. 7] (large di-
stance inside to the nozzle): no negative pressure
is generated, but blown into the blasting medium
line -> pressure build-up
NOTE!
There are no general guidelines for this setting. It
must be learned by testing, depending on the blasting
medium and requirement.
10
Step1:
Select a suitable blasting medium and fill in the
sandblasting booth.
Step 2:
The workpiece must be free of oil, grease and
moisture. If necessary, clean the workpiece be-
fore placing it in the blast cabinet.
Step3:
Set the desired working pressure at the com-
pressed air supply (compressor). Make sure
that the maximum pressure is not exceeded!
Adjust according to the sensitivity of the mate-
rial according to lower working pressure.
Step 4:
Connect the sandblast booth to the compres-
sed air source.
Step 5: Place the workpiece to be machined in the blast
cabinet, close the door and turn on the blast
cabinet lighting.
Step 6: Use the integrated protective gloves to hold the
sand blasting gun and the workpiece and start
sandblasting. Hold the sand blasting gun at an
angle of 45 ° to 60 ° to the workpiece, the abra-
sive should be blown from the workpiece against
the back wall of the sandblast cabine.Use the
pedal to dose the blasting agent addition.
Attention: When opening the cabin doors during
operation, the sandblasting booth switches off au-
tomatically.
Step 7:
After finishing work, disconnect the tool from
the compressed air source and remove the
workpiece.Pflege, Wartung und Instandset-
zung
ATTENTION
Disconnect the tool from the compressed air supply
and the sandblasting booth from the mains before
carrying out any maintenance, servicing or cleaning
work. Maintenance and repair work may only be car-
ried out by qualified personnel.
9
Care, maintenance and overhaul
9.1 Care by cleaning
The sandblasting booth should always be kept in a clean
condition.
Use protective gloves!
NOTE!
Never use harsh detergents for cleaning. This can
lead to damage or destruction of the device.
SSK 4 | Version 1.08
Advertisement
Table of Contents
