Demontage und Montage des Basicboards
Zur Demontage des Basicboards entfernen Sie zunächst
alle Zuleitungen. Drücken Sie dazu bei den Kabeln an Po-
sition 1 die mittige Verriegelung nach unten. Bei den Ka-
beln an Position 2 müssen Sie die beiden seitlichen Nasen
leicht nach unten drücken.
Entfernen Sie nun die markierten Schrauben und nehmen
Sie das Basicboard weg.
Die Montage erfolgt in umgekehrter Reihenfolge.
1
2
2
1
Disassembly and assembly of basic board
Unplug all cables before removing the PSU. Unlock the
connectors marked with (1) by pressing the middle latch
down. Unlock the connectors marked with (2) by pressing
both side latches slightly down.
1
2
Now remove all marked screws and remove the PSU.
The assembly is carried out in principle in reverse se-
quence.
12