Table of Contents
Advertisement
Section 2: Installation
To get your network up and running:
Set up your hardware.
Insert the CD-ROM for Software Setup. Follow the prompts.
If you prefer to set up the access point's software manually, refer to the Manual Software
Setup found in this section.
The following sections provide detailed instructions for completing these tasks.
Hardware Setup
Hardware setup includes:
Antenna Installation: verifying the antenna is connected to the access point.
Physical Installation: where you physically place your access point.
Electrical Connection: how to power your access point.
Antenna Installation
When shipped, the antenna is connected to the access point. If for some reason you need
to detach and reattach the antenna to the main access point:
1
Locate the antenna and its threaded connector on the back of the access point
2
To remove the antenna, unscrew the antenna connector counter-clockwise
3
To reattach the antenna, screw the antenna connector clockwise on to the threaded
knob until firmly seated. Do not over tighten.
WA840
2-1
Advertisement
Table of Contents
Troubleshooting
