KeeNetic Carrier KN-1711 Quick Start Manual

Quick Start Guide
AC1200 Dual Band Mesh Wi-Fi Router with
a 5-Port Smart Switch and USB Port
Model: KN-1711
Installing Your
Keenetic Carrier
1
Position your Keenetic Carrier (hereinafter 'Keenetic device')
within cable lengths of Ethernet and power outlets. Place
your Keenetic device in an open area for better wireless
coverage.
2
Connect your Keenetic device to a power
source. Check that both the Status LED C and
Wi-Fi LED D are illuminated and not blinking.
3
Сonnect a mobile device to your Keenetic device via Wi-Fi.
The default Wi-Fi name (SSID) and Wi-Fi password are
printed on your Keenetic device's back label along with
a QR code that will automatically connect your mobile device
to the Keenetic device's Wi-Fi when scanned. Alternatively,
сonnect a computer to any gray Ethernet port on your
Keenetic device using the included Ethernet cable.
4
Once connected, an Initial Setup Wizard window will appear on
your mobile device / computer. If the Wizard does not appear,
using a browser go to my.keenetic.net.
Note: If the Initial Setup Wizard doesn't appear, please refer
to the Frequently Asked Questions section below.
0 1 2 3 4
10:00
Welcome to
Your Keenetic
Next
For technical support or other information, please visit
help.keenetic.com
5
In the Initial Setup Wizard window that appeared, select the
configuration option.
To create a new network and connect it to the Internet, choose
the appropriate connection type and follow the setup instructions.
To extend an existing network and add this Keenetic device as
a Wi-Fi extender, choose the 'To switch to Wi-Fi Extender Mode'
option and follow the setup instructions.