Hyundai HL960A Operator's Manual page 224

(10) Operate the engine at low idle and inspect for
leaks at the filter and the drain plug.
Shut the engine off and check oil level with dip-
stick. Allow 15 minutes for oil to drain down
before checking.
※
Do not overfill the engine with oil. Do not overfill the engine with oil.
3) 3) CHECK COOLANT LEVEL CHECK COOLANT LEVEL
(1) Check the engine fault code on the monitor.
If you following fault codes exist, check the cool-
(2)
ant level.
·SPN : 111, FMI : 18
- Coolant level is low.
·SPN : 111, FMI : 1
- Coolant level is the most severely low.
(3) Add the mixture of antifreeze and water after
removing the cap of the surge tank if coolant is
not sufficient.
Replace gasket of surge tank cap when it is
(4)
damaged.
Do not remove the surge tank cap from a hot Do not remove the surge tank cap from a hot
engine. Wait until the coolant temperature is engine. Wait until the coolant temperature is
below 50˚C C (120 below 50 (120˚F) before removing the cap.
Heated coolant spray or steam can cause Heated coolant spray or steam can cause
personal injury. personal injury.
※
Do not add cold coolant to a hot engine ; Do not add cold coolant to a hot engine ;
engine castings can be damaged. Allow the engine castings can be damaged. Allow the
engine to cool to below 50˚C C (120 engine to cool to below 50
adding coolant. adding coolant.
) before removing the cap.
(120˚F) before ) before
6-17
NOT OK
Surge tank
Cap
Sight gauge
NOT OK
OK
F u
e l
t a n
k
760F6MI07
960A6MI20
760F6MI15