Hyundai HL960A Operator's Manual page 170

3. STARTING AND STOPPING THE ENGINE 3. STARTING AND STOPPING THE ENGINE
1) 1) CHECK INDICATOR LIGHTS CHECK INDICATOR LIGHTS
(1) Check if the parking brake switch is ON.
(2) Check if the gear selector lever is in neutral posi-
tion.
(3) Check if the pilot cut off switch is OFF.
(4) Turn the key to the ON position, and check fol-
lowings.
·
Cluster Cluster
①
If all the lamps light ON after sounding buzzer
for 3 seconds.
※
If the lamps do not light or the buzzer is not If the lamps do not light or the buzzer is not
sounded, check disconnection of wire. sounded, check disconnection of wire.
②
Only below lamps will light ON and all the other
light will be turn OFF after 3 seconds.
- Charging warning lamp (1)
- Engine oil pressure warning lamp (2)
- Brake fail warning lamp (3)
·
Monitor Monitor
①
The buzzer sounds for 3 seconds with
HYUNDAI logo on monitor.
②
If the ESL mode is set to the enable, enter the
password to start engine.
③
If the password has failed 5 times, please wait
30 minutes before re-attempting to enter the
password.
※
Refer to page 3-30 for ESL system setting. Refer to page 3-30 for ESL system setting.
Gear selector lever
Parking brake switch
Pilot cut off switch
Cluster
Monitor
4-3
OFF
1 2 3
760F4OP03