Page 1
35 E / 45 E / 60 E 35 E - 2 / 45 E - 2 / 60 E - 2 English Instantaneous shower water heater - Operation and installation instructions ไทย คู ่ ม ื อ แนะนำ � ก�รใช้ ง �นและติ ด ตั ้ ง เครื ่ อ งทำ � น้ ำ � อุ ่ น This shower water heater must be installed (water and electrical installation), commissioned and serviced by approved service technicians in accordance with these instructions.
Dimension Using the installation template to drill the holes 4 x 25 mm 6 mm 4 x 25 mm 6 mm min. 4.5 mm max. 5.5 mm Fig 1 Fig 3 Wall Mounting Cable Fig 2 Fig 4 STIEBEL ELTRON...
Page 6
- Electronic control set b - Electronic control set c - ELSD Circuit c - Triac Set d - Triac Set d - Thermostat e - Thermostat f - Button Board g - Current Leakage Sensor Fig 5 STIEBEL ELTRON...
- Feed the connection cable seal in - Release cover securing screw. the rear wall. Fig 7 Fig 9 - Open and remove cover. - Guide the unit along the wall and lock screw in fixing hole by sliding downwards. Fig 8 Fig 10 STIEBEL ELTRON...
Page 9
Fig11 Fig 12 - Fit a secure connection cable (Ground, L, N) and ensure the dimensions are correct. (see cable size - Fit the cover and secure with the screw. in Technical Data). Fig13 Fig 14 STIEBEL ELTRON...
Page 10
- Fit the shower accessories to the hot water pipe thoroughly. - The outlet must not be connected to any - Fit the filter and silicone gasket . tap or fitting other than those specified. Fig 16 Fig 18 STIEBEL ELTRON...
2.1 Description of the unit. This appliance is designed for The Stiebel Eltron IS pressureless domestic use. It can be used safely by (open) instantaneous water heater is a untrained persons. The appliance can device for heating water for shower.
A periodical C. “Power” light scale removal is essential for the func- D. Shower accessories tion of the shower head. Shower head level must not be higher than the unit. Fig 19 STIEBEL ELTRON...
- Read & study the technical data. - Install the unit vertically on the wall. - Electrical connection to be secured. The unit must be earthed (see circuit diagram). To protect against water penetration, the cable seal (Fig. 6 No. 2) must be used. STIEBEL ELTRON...
4.2 - 17.5 5.4 - 22.5 7.1 - 29.6 Note: The cable sizes can only be a guiding value. Always abide by the corresponding local standards, laws and regulations. Stiebel Eltron cannot be held liable for any damages. STIEBEL ELTRON...
Disconnect water valve (Fig. 6 No. similarly qualified persons in order to 17), remove filter (Fig. 6 No. 14) and avoid a hazard. clean. Re-assemble in reverse order. Material losses Observe the max permissible inlet temperature. Higher temperatures may damage the appliance. STIEBEL ELTRON...
- Filter in the cold - Clean the filter after water connection pipe shutting off the cold blocked with dirt. water intake. - Water pressure not - Increase mains enough pressure STIEBEL ELTRON...
4 x 25 mm 6 mm 4 x 25 mm 6 mm min. 4.5 mm max. 5.5 mm ภ�พที ่ 1 ภ�พที ่ 3 วิ ธ ี ก �รแขวนเครื่ อ งบนผนั ง ขน�ดคว�มย�วส�ยไฟจ�กผนั ง ภ�พที ่ 2 ภ�พที ่ 4 STIEBEL ELTRON...
Page 18
- Electronic control set b - Electronic control set c - ELSD Circuit c - Triac Set d - Triac Set d - Thermostat e - Thermostat f - Button Board g - Current Leakage Sensor ภ�พที ่ 5 STIEBEL ELTRON...
Need help?
Do you have a question about the IS 35 E and is the answer not in the manual?
Questions and answers