Using Your Remote Control - Code Alarm CA 1150 Owner's Manual

Using Your Remote Control

Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the
parking lights will flash 2 times, indicating the system is armed, has locked the
doors (if equipped and connected) and activated the starter disable feature. The
LED status indicator will blink steadily, once per second.
NOTE: The system is defaulted with Silent Choice enabled, which requires a
second press of the
vehicle.
Bypassing The Shock Sensor
To arm the system and ignore the shock sensor press
seconds press
NOTE: The system will only change the shock sensor setting for one arm cycle
and will be defaulted back to normal operation the next time the system is armed.
Disarming the Security System
To disarm the system press the
indicating the system is disarmed and has unlocked the doors (if equipped and
connected).
NOTE: The system is defaulted with Silent Choice enabled, which requires a
second press of the
vehicle.
Two Stage Door Unlock (Optional)
If this feature is enabled on your system, pressing the
unlock only the driver's door. Press
remaining doors.
Valet Mode
To engage valet mode:
1. Turn the ignition key to the ON position.
2. Press and hold the emergency override button.
3. The LED will light solid indicating that the system is in valet mode.
When valet mode is activated the status LED will light solid, and all security
functions will be disabled.
*Throughout this manual, 'press' refers to pressing for less than 1 second; 'press and hold' refers to pressing for more
than 2 seconds.
2009 Audiovox Electronics Corporation. All rights reserved.
button to activate an audible arming response from the
+ , the system will respond with 1 long chirp.
button. The parking lights will flash 1 time,
button to activate an audible arming response from the
again within 5 seconds to unlock the
button. The
button, then within 5
button one time will
3