Using Your Remote Control; Arming The Security System; Disarming The Security System; Manually Overriding The Security System - Code Alarm Professional Series Owner's Manual

Using Your Remote Control

Arming the Security System

To arm the system, exit the vehicle, close all doors, then press the
parking lights will flash 2 times, indicating the system is armed, has locked the doors
(if equipped and connected) and activated the starter disable feature. The LED status
indicator, if installed, will blink steadily, once per second.

Disarming the Security System

To disarm the system press the
the system is disarmed and has unlocked the doors (if equipped and connected).

Manually Overriding the Security System

Your system can be disarmed without the use of the transmitter. This is necessary,
since you will need the ability to operate your vehicle if the transmitter is lost or its
battery fails. To by-pass the alarm system;
1. Open the vehicle door. The alarm will sound.
2. Cycle the ignition key ON, OFF, ON.
3. Within 10 seconds, press and release the Brake pedal 3 times.
The alarm system will stop sounding and enter the (by-passed) mode. You can now
start and operate the vehicle normally.

Valet Mode

When Valet Mode is activated the status LED, if installed, will light solid, and all
security and remote start functions will be disabled. This is used to disable remote
start activation as well as preventing the alarm from triggering when the vehicle is
being serviced or driven by a valet driver.
To enter or exit valet mode simply follow the steps outlined below:
1. Open the vehicle door.
2. Cycle the ignition key ON, OFF, ON.
3. Within 10 seconds, press and release the Brake pedal 3 times.
2019 Voxx Electronics Corporation. All rights reserved.
button. The parking lights will flash 1 time, indicating
button. The
3