Troubleshooting - Magmaweld MKM 720S TURBO User Manual

MKM 720S / TURBO

3.4 Troubleshooting

Failure
Irregular dimming
Solarmatic filter does not
darken or light Shivers
Slow response
Restricted view
Welding mask slips
www.magmaweld.com
• The headband is unbalanced and there is an inappropriate distance
between the eye and the filter lens. Adjust the headband from the side
to reduce the distance to the filter.
• The front cover lens is dirty or damaged. Replace the front cover lens.
• The sensors are dirty. Clean sensor surfaces.
• Welding current is too low. Set the sensitivity setting to "Highest"
direction.
• Blackening speed is too low. Do not use at temperatures below -10 ° C.
• The lens on the front cover and / or inside is dirty. Replace lenses.
• Ambient light is insufficient.
• The blackout number is incorrectly selected. Set the dimming number
again.
• The headband is not properly adjusted. Set it again.
USER MANUAL | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Maintenance and Service
Solution
11
EN