Troubleshooting - Magmaweld MKM 620MA User Manual

10 Maintenance and Service

3.4 Troubleshooting

EN
Failure
Irregular dimming
Solarmatic filter does not
darken or light Shivers
Slow response
Restricted view
Welding mask slips
USER MANUAL | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
• The headband is unbalanced and there is an inappropriate distance
between the eye and the filter lens. Adjust the headband from the side
to reduce the distance to the filter.
• The front cover lens is dirty or damaged. Replace the front cover lens.
• The sensors are dirty. Clean sensor surfaces.
• Welding current is too low. Set the sensitivity setting to "Highest"
direction.
• Blackening speed is too low. Do not use at temperatures below -10 ° C.
• The lens on the front cover and / or inside is dirty. Replace lenses.
• Ambient light is insufficient.
• The blackout number is incorrectly selected. Set the dimming number
again.
• The headband is not properly adjusted. Set it again.
MKM 620MA / CORE
Solution
www.magmaweld.com