Perform Spo2 Monitoring With Masimo Option - Welch Allyn Propaq Encore 202EL Reference Manual

Pulse Oximetry (SpO2)
If NIBP will be monitored while using SpO
SpO sensor to help reduce unnecessary SpO
2
placing the SpO sensor on the same limb as an arterial catheter or intravascular line.
2
Loss of pulse signal can occur if the sensor is too tight, there is excessive ambient light, an
NIBP cuff is inflated on the same limb as the sensor, there is arterial occlusion proximal to the
sensor, the patient is in cardiac arrest or shock, or the patient has hypotension, severe
vasoconstriction, severe anemia, or hypothermia.
Perform SpO Monitoring with Masimo Option
2
1. Attach the sensor to the patient according to the sensor manufacturer's instructions,
observing all warnings and cautions.
Warning Use only Masimo accessories and sensors with the monitor with
Masimo SpO
booklet (810-0409-XX).
2. Inspect the Masimo SpO
fraying. Plug the sensor into the cable and plug the cable into the Propaq monitor.
The monitor displays STANDBY in the SpO
and displays the SpO
As oxygen saturation increases and decreases, the pitch of the heart tone
rises and falls.
The monitor self-calibrates the SpO
turned on or a sensor is first connected to the SpO
3. From the Main Menu, press
similar to the following:
MON
S S
p
Y
1
O N x
C
2
SIZE
Propaq Encore Reference Guide
, place the NIBP cuff on a different limb than the
2
2
option as listed in the Welch Allyn Products and Accessories
2
cable. Replace it if it shows any signs of wear, breakage, or
2
value.
2
(or
SpO2 SpO2/CO2
MORE
alarms. For optimal measurements, avoid
numeric window until it measures
2
channel whenever the monitor is first
2
channel.
2
, then ) to display the SpO
SpO2
58
( 85)
S p O
2
99
PREV MENU
Pulse amplitude indicator
(not proportional to pulse volume)
69
menu
2
Oxygen
saturation
percentage
Welch Allyn