Agilent Technologies N9360A Programming Manual page 64

5
Programming Command Reference
5-18
This command specifies the amplitude (BS Level) of the Tester
for Bit Error Ratio (BER) test in each band set by the
command described on
to (dBm) in
-110.0 -20.0
(dBm).
-106.7
BER Frame
CONFigure:SEQuence:SENSitivity:FRAMe <int>
CONFigure:SEQuence:SENSitivity:FRAMe?
This command specifies the number of the frames for BER. The
allowable range is from
this is set to .
10
FreqError BS Level
CONFigure:SEQuence:FRQbslevel <real>
CONFigure:SEQuence:FRQbslevel?
This command specifies the amplitude (BS Level) of the Tester
for frequency error test in each band set by the
described on page 16. The allowable range is from
(dBm) in steps. At preset, this is set to
-20.0 0.1
RF Signal Output Mode
CONFigure:SEQuence:RFOUtput AUTO|ON
CONFigure:SEQuence:RFOUtput?
This command specifies RF Output in Automatic Test. At preset,
this is set to . The parameter is
ON
set to .
ON
This query command returns the RF signal output setting with
string of or .
AUTO ON
Wait before Paging
CONFigure:SEQuence:WaitBeforePaging <int>
CONFigure:SEQuence:WaitBeforePaging?
N9360A Multi UE Tester W-CDMA Programming Manual
page 16. The allowable range is from
steps. At preset, this is set to
0.1
to (frames) in
1 4100
or . At preset, this is
AUTO ON
Band
step. At preset,
1
Band command
to
-110.0
(dBm).
-50.0