Indoor Unit; Remote Controller; Outdoor Unit - Mitsubishi Electric MSZ-GS30NA2 Operating Instructions Manual

● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART

Indoor unit

Air cleaning fi lter
(Anti-Allergy Enzyme Filter)
Air fi lter
(Nano platinum fi lter)
Air inlet
Air outlet
Horizontal vane
Fan guard

Outdoor unit

Outdoor units may be different in appearance.
En-3
Front panel
Emergency
operation
switch
Page 11
Operation indicator
lamp
Remote control
receiving section
Air inlet (back and side)
Refrigerant piping
Drainage hose
Air outlet
Drain outlet

Remote controller

Battery replacement indicator
Temperature
buttons
Pages 4, 5, 6
Operation
select button
Pages 5, 6
ECONO COOL
button
Page 8
POWERFUL
button
Page 8
SMART SET
button
Page 8
CLOCK button
Page 4
Remote controller holder
• Install the remote con-
troller holder in a place
where the signal can be
received by the indoor
unit.
• When the remote con-
troller is not used, place
it in this holder.
* The backlight turns on when using the remote controller.
The backlight goes off if the remote controller is not used for a while.
Signal transmitting
Page 4
section
Distance of signal :
About 20 ft. (6 m)
Beep(s) is (are) heard from
the indoor unit when the
signal is received.
OFF/ON
(stop/operate) button
FAN speed control
button
Page 7
WIDE VANE
button
Page 7
VANE control
button
Page 7
TIME, TIMER set buttons
Pages 4, 9
forward button
backward button
TIME, WEEKLY TIMER
set buttons
Pages 4, 9, 10
RESET button
Page 4
Lid
Slide the lid down
to open the remote
controller. Slide it down
further to get to the
weekly timer buttons.
Only use the remote controller provid-
ed with the unit.
Do not use other remote controllers.
If two or more indoor units are installed
in proximity to one another, an indoor
unit that is not intended to be operated
may respond to the remote controller.