Table of Contents
Advertisement
Figure 89. Installing the system battery
Next steps
1. If applicable,
Install the expansion card riser
2. Follow the procedure listed in the
3. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup Time and Date fields.
c. Exit the System Setup.
d. To test the newly installed battery, remove the system from the enclosure for at least an hour.
e. Reinstall the system into the enclosure after an hour.
f. Enter the System Setup and if the time and date are still incorrect, see
Optional internal USB card
NOTE:
To locate the internal USB port on the system board, see the
Removing the optional internal USB card
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm width x 57.15 mm length x 7.9 mm height.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
1. Holding the blue tag, lift the internal USB card to disconnect from the connector on the system board.
2. Remove the USB memory key from the internal USB card.
86
Installing and removing system components
and connect the cables to the expansion card(s).
After working inside your
Safety
instructions.
Before working inside your
system.
Getting help
System board jumpers and connectors
system.
section.
section.
Advertisement
Table of Contents
