Table of Contents
Advertisement
Installation
M
OUNTING
The HRE-506 may be mounted in a rack, pole, pedestal, or flat surface, using the enclosure mounting bracket
assembly.
Figure 4 on page 9
bracket.
For all installations, the enclosure must be mounted vertically. In addition, a shady location is
preferred to minimize thermal stress. Refer to
information.
The mounting instructions for the various methods are:
•
Small pole or pedestal mounting with a diameter less than or equal to 7 inches (17.78 cm), see
or Pedestal Mounting" on page
•
Pole mounting with a diameter greater than 7 inches (17.78 cm), see
•
Flat-surface mounting, see
•
Rack mounting, see
While mounting the enclosure using any of these procedures, hold the enclosure securely to
prevent personal injury or damage to the enclosure.
Because of the size and weight of the enclosure, you may want to remove the dome before
beginning the mounting procedure. For more information, see
Baseplate" on page
8
details the enclosure dimensions and
11.
"Flat Surface-Mounting" on page
"Rack Mounting" on page
19.
March 28, 2000
Figure 5 on page 10
Table 4 on page 33
"Large Pole Mounting" on page
12.
13.
"Detaching the Dome from the
150-506-100-03
shows the mounting
for thermal load capacity
"Small Pole
12.
HRE-506 List 1 and List 2
Advertisement
Table of Contents
